top of page

OUR RESEARCH - COATING TRIBOLOGY

MMC TRIBOLOGY

Metal matrix composites are made by a variety of techniques. Our research focuses on fabrication of MMCs by cold spray. We have studied a variety of material systems: Ti-TiC, Cu-MoS2, Ni-WC and Ti6Al4V-TiC. Our research addresses the deposition characteristics of metal-ceramic mixtures by cold spray and the properties and tribological performance of MMC coatings.

Sample of Specific Publications

Y. Zhang, Y. Epshteyn, R.R. Chromik, “Dry sliding wear behaviour of cold-sprayed Cu-MoS2 and Cu-MoS2-WC composite coatings: the influence of WC,” Tribology International 123, 293-306 (2018).
S.A. Alidokht, S. Yue, R.R. Chromik, “Effect of WC morphology on dry sliding wear behavior of cold-sprayed Ni-WC composite coatings,” Surface and Coatings Technology 357, 849-63 (2019).
S.A. Alidokht, V.N.V. Munagala, R.R. Chromik, “Role of third bodies in friction and wear of cold-sprayed Ti and Ti-TiC composite coatings,” Tribology Letters 65, 114 (2017).
J.M. Shockley, C. Desrayaud, R.R. Chromik, S. Descartes, “Significance of Al2O3 particle morphology in the microstructure evolution of cold-sprayed Al-Al2O3 during unconstrained high-pressure torsion,” Materials Science and Engineering A 684, 510-16 (2017).
J.M. Shockley, E.F. Rauch, R.R. Chromik, S. Descartes, “TEM microanalysis of interfacial structures after dry sliding of cold sprayed Al-Al2O3,” Wear 376, 1411-17 (2017).
Y. Zhang, D. Choudhuri, T.W. Scharf, S. Descartes, R.R. Chromik, “Tribologically induced nanolaminate in a cold-sprayed WC-reinforced Cu matrix composite: a key to high wear resistance” Materials and Design 182,108009.

Go Back to Our Research Page

bottom of page